// This example just provide basic LoRa function test;
// Not the LoRa's farthest distance or strongest interference immunity.
// For more informations, please vist www.heltec.cn or mail to support@heltec.cn

#include <SPI.h>
#include <LoRa.h>
#include<Arduino.h>

// WIFI_LoRa_32 ports

// GPIO5  -- SX1278's SCK
// GPIO19 -- SX1278's MISO
// GPIO27 -- SX1278's MOSI
// GPIO18 -- SX1278's CS
// GPIO14 -- SX1278's RESET
// GPIO26 -- SX1278's IRQ(Interrupt Request)

#define SS      18
#define RST     14
#define DI0     26
#define BAND    433E6  //915E6 -- 这里的模式选择中，检查一下是否可在中国实用915这个频段

int counter = 0;

void setup() {
  pinMode(25,OUTPUT); //Send success, LED will bright 1 second
  
  Serial.begin(115200);
  while (!Serial); //If just the the basic function, must connect to a computer
  
  SPI.begin(5,19,27,18);
  LoRa.setPins(SS,RST,DI0);
//  Serial.println("LoRa Sender");

  if (!LoRa.begin(BAND)) {
    Serial.println("Starting LoRa failed!");
    while (1);
  }
  Serial.println("LoRa Initial OK!");
}

void loop() {
  Serial.print("Sending packet: ");
  Serial.println(counter);

  // send packet
  LoRa.beginPacket();
  LoRa.print("hello ");
  LoRa.print(counter);
  LoRa.endPacket();

  counter++;
  digitalWrite(25, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);                       // wait for a second
  digitalWrite(25, LOW);    // turn the LED off by making the voltage LOW
  delay(1000);                       // wait for a second
  
  delay(3000);
}